Firmware Flashing Instructions
Notes
- The PRO X10 comes pre-flashed with Katapult
- Once BL has been flashed, there is no need to flash BL again
- The PRO X10 has two types of BL: Katapult firmware and BL firmware flashed via TF card
- If needed, you can re-TF Card Bootloader Brick Recovery according to your preference
Important
- The mainboard firmware must be flashed with Klipper via Katapult
- If you are sure the mainboard has already been flashed with Katapult, there is no need to perform the Katapult firmware flashing at the end
- You can quickly press reset twice and check if an LED on the mainboard starts blinking. If it does, the mainboard has entered Katapult firmware
Selecting the Firmware Type
Please confirm the connection method first
- Not using a CAN toolboard: Select USB firmware.
- When a CAN toolboard is required: Select USB-to-CAN Bridge Firmware.
- Only one of the two firmware types can be selected; do not flash both. The Pro X10 firmware supports updating via USB Katapult.
| Firmware Type | Applicable Scenario | Advantages | Confirm Before Selecting | Operation |
|---|---|---|---|---|
| USB Firmware | When not using a CAN toolboard | Stable communication, simple configuration | Use USB firmware when not using a CAN toolboard | Compile USB Firmware |
| USB to CAN Bridge Firmware | When a CAN toolboard is required | Can connect multiple CAN devices, reducing USB usage | Select only when a CAN toolboard is needed; confirm CAN wiring, termination resistors, and CAN rate configuration are consistent | Compile USB to CAN Bridge Firmware |
DIP Switch Instructions
Please Pay Attention to the DIP Switch Status
Loading...
TF Card Slot Usage Instructions
Loading...
Loading...