Quick Start
Objective of this guide: Complete the system deployment and basic configuration of the FLY-Lite2 within 30 minutes, bringing it to a state where the Klipper web interface is accessible.
Completion indicator: Access the Klipper web interface via a browser.
Important Notes
- Required accessory: The FLY-Lite2 must be used with a TF card, otherwise the system will not boot
- Power requirements: Only supports 5V input, do not connect higher voltages
- Safety operation: The printer must be powered off and disconnected from the power supply before any wiring operations
- System startup: It is recommended to complete the configuration via network SSH on the first startup
Step 1: Prepare Tools and Resources
Loading...
Contents include:
MobaXterm- Used for connecting to the host machineCH340- Serial port driver used for system connectionPanasonic_SDFormatter- Used for formatting the TF cardSetupSTM32CubeProgrammer- Used for flashing the firmware to the controller board
Step 2: Install the System and Basic Configuration
| Configuration Item | Description | Link |
|---|---|---|
| System Image Flashing | Flash the FlyOS system image | View Guide |
| Basic System Configuration | Modify system configuration | View Guide |
| SSH Connection | Remotely connect to the host machine | View Guide |
| Wi-Fi Configuration | Configure the wireless network | View Guide |
| Screen Configuration | Configure the display device (optional) | View Guide |
| Host Machine Power Supply | Choose the correct power supply method | View Guide |
Notes:
- Please confirm that the TF card has been properly formatted before flashing the image
- The first system startup may take 3-5 minutes, please be patient
- The default SSH username is
rootand the password ismellow
Step 3: Extended Features and Advanced Configuration
The following features can be configured step by step as needed after completing the basic setup and ensuring the printer operates normally:
| Feature | Description | Link |
|---|---|---|
| Camera Usage | USB camera configuration | View Guide |
| Resonance Compensation | Use an accelerometer for input shaping | View Guide |
| External Tool Board | Tool board connection and ID retrieval | View Guide |
| Resource Download | 3D models and schematics | View Guide |
Recommendations:
- It is recommended to configure and test extended features one by one to avoid changing too many parameters at once
- Camera configuration requires additional USB camera device support
- Resonance compensation requires an accelerometer sensor
- Tool board connection is applicable to multi-toolhead 3D printers
Loading...